The applicant that declares compliance of its products with safety standards in accordance with Paragraph 3, Article 7 of the Act shall take any one of the following approaches to demonstrating compliance by transmitting related test reports through the Internet and maintaining them for checks.1. To obtain type verification from verification bodies recognized by the central competent authority;2. To obtain certification from product certification bodies accredited by domestic or foreign accreditation bodies; or3. To complete self-inspection and self-check of production consistency to ensure compliance with the safety standards.For luminaires, motors and switch boxes used in explosive atmosphere, power press or shearing machinery, woodworking circular saws and grinding machinery the approach to demonstrating compliance will be limited to subparagraph 1 of the preceding paragraph.The following requirements shall apply if the approach stated in Subparagraph 3 of Paragraph 1 is taken:1. Self-inspection shall be performed by testing laboratories accredited by accreditation bodies,2. Self-check of production consistency shall be performed by bodies accredited by accreditation bodies; and3. The qualification of testing personnel of testing laboratories shall comply with criteria specified in Attaching table 1.For registration of a single article, the self-check of production consistency is waived if the approach of Subparagraph 3 of Paragraph 1 is taken.Table 1.PDF