Regulations for Safety Inspection of Hazardous Machines and Equipment Article 160
In case any of the following situations exists, the Owner/ Employer of the vessels for high pressure gases shall submit the Inspecting Organization an application for re-inspection:1. The vessel to be used is imported from foreign countries.2. The vessel to be installed or re-used, has been idle for over one (1) year since the last qualification date of the structure inspection, re-inspection, completion inspection or periodic inspection of said vessel. However,the above requirements may be exempted for those vessels approved by the Inspection Organization.3. The vessel intended to be re-used, has previously been prohibited by the Inspection Organization.4. The maximum bottling pressure is intended to be up-rated.5. The category of the bottled gases is intended to be changed.For those imported vessels which are documented by proper supporting inspection certificates, the Inspecting Organization may grant a full or partial exemption from the requirements as stipulated in this Article.
中文原文 危險性機械及設備安全檢查規則第160條
高壓氣體容器有下列各款情事之一者，應由所有人或雇主向檢查機構申請重新檢查：
一、從外國進口。
二、構造檢查、重新檢查、定期檢查合格後，經閒置一年以上，擬恢復使用。
但由檢查機構認可者，不在此限。
三、經禁止使用，擬恢復使用。
四、擬提升最高灌裝壓力。
五、擬變更灌裝氣體種類。
對外國進口具有相當檢查證明文件者，檢查機構得免除本條所定全部或一部之檢查。
一、從外國進口。
二、構造檢查、重新檢查、定期檢查合格後，經閒置一年以上，擬恢復使用。
但由檢查機構認可者，不在此限。
三、經禁止使用，擬恢復使用。
四、擬提升最高灌裝壓力。
五、擬變更灌裝氣體種類。
對外國進口具有相當檢查證明文件者，檢查機構得免除本條所定全部或一部之檢查。