An applicant shall apply to the CAA for a Parts Manufacturers Approval. An applicant is entitled to a PMA Certificate (see Attachment 14) if its part is properly certified by CAA .The applicant shall submit to CAA the following:1) The PMA application form (see Attachment 15);2) The identity of the product on which the part is to be installed;3) A document describing its organization, manufacturing facilities and locations;4) Drawings and specification necessary to show the configuration of the part;5) Information on dimensions, materials, and processes necessary to define the structural strength of the part; and6) Test reports and computations necessary to show that the design of the part meets the applicable airworthiness requirements, unless the applicant shows that the design of the part is identical to the design of a part that is covered under a type certificate. If the design of the part was obtained by a licensing agreement, evidence of the agreement must be furnished.Attachment 14 PARTS MANUFACTURER APPROVAL.odtAttachment 15 APPLICATION FOR PARTS MANUFACTURER APPROVAL.odt