Regulations Governing the Collection of Air Pollution Control Fee Article 10

The air pollutant emissions of a stationary pollution source in any public or private premises that is subject to Article 3 of this Act should report air pollution control fees calculated based on data in the following order:I. The monitoring data of the stationary pollution source’s continuous automatic monitoring equipment or facilities that are in compliance with the regulations of the central competent authority.II. The plant-specific factor of volatile organic compound from public or private premises recognized by the central competent authority.III. The air pollution test methods and test results consistent with the regulations of the central competent authority, or air pollution emission factors, control efficiency rate and quality/quantity balance measurement method designated by the central competent authority.IV. Other emission factors and alternative calculation methods authorized by the central competent authority.In any report of emission of volatile organic compound by stationary pollution source in a public or private premise, the emission shall be calculated by using air pollution emission factors calculated in accordance with subparagraph 2 of the previous paragraph, control efficiency rate and mass balance measurement method designated by the central competent authority as stated in subparagraph 3 of the previous paragraph, or the requirement set forth in subparagraph 4. However, if the stationary pollution source uses a closed vent system to emit volatile organic compounds into the exhaust pipe, the emission may be calculated in accordance with subparagraph 1 of the previous paragraph or the air pollution test methods and test results consistent with the regulations of the special municipality, county or city competent authority as stated in subparagraph 3 of the previous paragraph, after submitting relevant information to and acquiring consent from the central competent authority.Plant factors referred to in subparagraph 2, paragraph 1 mean the alternative calculation method filed by the stationary pollution source in accordance with the Guidelines for Establishment of Stationary Pollution Source Volatile Organic Compound Plant Factor (Including Control Efficiency) and approved by the central competent authority.The emission factor in subparagraphs 3 and 4 of the first paragraph refers to the unit raw materials (goods) of stationary pollution source unit output, fuel usage quantities, production output or the air pollutant emissions quantities produced by other operating quantities recognized by the central competent authority.The stationary pollution sources at public or private premises that calculate their air pollutant emissions quantities shall calculate the air pollutant emission in accordance with the formula announcemed by the central competent authority.