Regulations Governing Verification and Inspection of Measuring Instruments Article 2
The term “verification” used in these Regulations are classified and defined as follows:1.Initial Verification: means the verification of legal measuring instruments subject to verification which is conducted before the measuring instruments being released from the production premises or imported. However, under the agreement of the dedicated weights and measures authority, it can also mean the verification conducted on-site after the measuring instruments being installed or while in-use.2.Re-verification: means the verification of legal measuring instruments subject to verification which is conducted when the validity period of the previous verification expires or after being repaired, adjusted or re-modeled, or while in-use.The term “verification agency (institution)” used in these Regulations means the dedicated weights and measures authority or its branches, or any other government agencies, institutions or organizations commissioned by the dedicated weights and measures authority.
中文原文 度量衡器檢定檢查辦法第2條
本辦法所稱檢定，其分類及定義如下：
一、初次檢定：指應經檢定之法定度量衡器，於製造出廠前或輸入時之檢定。
但經度量衡專責機關同意者，指於安裝後或使用中之檢定。
二、重新檢定：指法定度量衡器經檢定合格之有效期間屆滿或經修理、調整、改造後或使用中之檢定。
本辦法所稱檢定機關（構），指度量衡專責機關、其所屬分局或受委託之其他政府機關（構）、團體。
一、初次檢定：指應經檢定之法定度量衡器，於製造出廠前或輸入時之檢定。
但經度量衡專責機關同意者，指於安裝後或使用中之檢定。
二、重新檢定：指法定度量衡器經檢定合格之有效期間屆滿或經修理、調整、改造後或使用中之檢定。
本辦法所稱檢定機關（構），指度量衡專責機關、其所屬分局或受委託之其他政府機關（構）、團體。